UL flap position plate

[Garyo]

Has anyone re created the ali position plate in another material yet, im on my third 1 since ownership and need to replace it again, its th 0, 15, 40 one
Was thinking of 2mm stainless steel
Has anyone done a drawing of it
Gary

[Steevo]

I have never used or had one. I use an inclinometer. Only a few quid and lasts forever and will do any aircraft.

[Garyo]

Stevo, think you have read it wrong, its the plate that the peg from the flap handle goes in, they wear inbetween the holes due to a poor design set up

[Steevo]

Sorry Gary. Yes, did read it wrong. I am on my third one.