Jabiru Owners Group

Welcome to the world of Jabiru

Oil Pressure LED

Find information on installing electrics and aircraft instruments.
  • Advertisement

Oil Pressure LED

Postby Admin » Wed Feb 11, 2015 5:14 pm

Originally posted by Andy Hollit

A jumbo flashing LED wired to the on/off terminal on the oil pressure sender warns of low oil pressure and reminds you to shut off the master switch!

Safety flange on the master switch to avoid switching it instead of the fuel pump!

One earth point only on the firewall.

An earth wire must run from the earth buss to the tank earthing point.

Instrument bussbars must be mounted on plastic standoffs to prevent live bolt heads.

Mount a 50 Watt anti collision light on the nosewheel leg (Rocca's etc). On all the time.

Forget about a strobe, no one will see it, unless you fly at night! But; if you land later than anticipated, mount a Dick Smith swivel torch, Y2154 in plastic conduit to the upper spine behind the crossbeam (where the headsets are normally stored) to illuminate the panel.

A red filter will stop reflections off the windscreen and retain your night vision.
Jabiru UL-450 built 2000 S/N 589
CAMit Alternator
Panel Throttles
MGL Explorer EFIS
Trig TT21 Mode S Transponder
Funkwerk ATR833 8.33khz Radio
Flight Data Systems GD-40 CO Monitoring
PowerFlarm Collision Avoidance
PS Engineering PM3000 Intercom
Site Admin
Site Admin
Posts: 124
Images: 98
Joined: Tue Feb 03, 2015 11:00 pm
Aircraft: Jabiru UL-450

Return to Electrical & Instruments

Who is online

Users browsing this forum: No registered users and 1 guest