Jabiru Owners Group

Welcome to the world of Jabiru

Bleeding the Brakes

Information on Jabiru wheels.
  • Advertisement

Bleeding the Brakes

Postby Admin » Fri Feb 13, 2015 3:41 pm

Originally posted by Vic Leggott

When bleeding the brakes have both brake calipers removed from the discs with a small clamp holding the slave piston in on one side. On the other side, hold the caliper up above the master cylinder with the piston and seal removed. Fill the master cylinder with brake fluid and slowly pump the brake. Be sure to keep the master cylinder topped up to prevent pumping air into the system. Pump the fluid up to the open cylinder until it is brimmed and no bubbles come out. Keeping the slave cylinder level insert the rubber brake seal in sideways and then rotate cup side in, trying to prevent air being trapped. Insert the steel piston and put a temporary clamp on it. Carry out the same procedure on the other side. It is helpful to tape some kitchen towel around the brake pipe to the calipers to catch any spills.

Later kits have bleed nipples fitted to the slave cylinders so ignore the above.
Jabiru UL-450 built 2000 S/N 589
CAMit Alternator
Panel Throttles
MGL Explorer EFIS
Trig TT21 Mode S Transponder
Funkwerk ATR833 8.33khz Radio
Flight Data Systems GD-40 CO Monitoring
PowerFlarm Collision Avoidance
PS Engineering PM3000 Intercom
Site Admin
Site Admin
Posts: 127
Images: 98
Joined: Tue Feb 03, 2015 11:00 pm
Aircraft: Jabiru UL-450

Return to Wheels

Who is online

Users browsing this forum: No registered users and 0 guests